Just a little somthing we are working on

[The_Shmoo]

You have your guys hand turning these, or do you have a CNC lathe?

[Bigbadpoppa]

Neither was I p226 came in plastic?!. Older models?

Mine is metal, navy version. Bought new.

[badboybeeson]

You have your guys hand turning these, or do you have a CNC lathe?

Ita on the to do list but alot of other projects t to finish off first

[Percussion]

Glock20 gen 4, with heavier springs as a kit (if possible)
Tired of losing all that 10mm brass

[srnm]

Is this project dead?

[badboybeeson]

Is this project dead?

NOT DEAD , JUST DELAYED .
was not as much interest as we had hoped so we have not done that yet

[srnm]

Thanks good to hear its not dead. When you start producing them i'm in for a blued gen 4 glock 17.... I'm honestly surprised of the lack of interest. I can't stand plastic guide rods...

[Shorerider]

I’m looking at getting one for my gen 3 G19 to tune it for the comp I just put on.

[DRE369]

I'm in for one for those Taurus PT92 AFS you had, for sure.

[MkivSupra]

id love one for my m9a3