Originally Posted by Brianma65 My Stag 10 is a littl over 8 lbs and I have a 20 inch barrel. I didn’t need to turn it down or cut it off 20 is just too long imo, all my hunting rifles in 308 would have 16" barrels if I had it my way, but we have to play the legality game
If it's either loud, obnoxious, fast, hated by the general population or any combination of these, I OWN IT!!
Originally Posted by Brian46 20 is just too long imo, all my hunting rifles in 308 would have 16" barrels if I had it my way, but we have to play the legality game Well if 1.4 inches is to much, just chop it off with a hacksaw and recrown it.
Originally Posted by Brianma65 Well if 1.4 inches is to much, just chop it off with a hacksaw and recrown it. When it is already in the lathe to get turned down it will get chopped
Some Diamond Head Forends on your webpage would probably sell...the same ones Stag Puts on their Rifles.
I second the diamondhead forearms idea
Originally Posted by ViktorF Some Diamond Head Forends on your webpage would probably sell...the same ones Stag Puts on their Rifles. The one you posted is for the low receiver height. This takes the high profile. But ya, the diamondhead handguard is nice
Would the Odin 02 lite 17.5 fore end work?
Any chance we'd see a 7mm-08 setup?
Originally Posted by Brianma65 My Stag 10 is a littl over 8 lbs and I have a 20 inch barrel. I didn’t need to turn it down or cut it off Did you end up using the faxon pencil barrel ?
Originally Posted by tstormt Did you end up using the faxon pencil barrel ? i just for pics, s I don’t have a buffer and spring
Forum Rules