 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
Has anyone put an Elcan Spectre DR 1.5-6X on one of these? I’ve read some of the reviews on the optic in other forums, and have seen they don’t lockup tight on some guns, and the arms levers aren’t adjustable I guess. Just want to confirm the rail on these receivers are in spec and the Elcan will lockup before I buy one
Pardon the rookie question but will any AR15 barrel fit on a ATRS upper? The reason I ask (for a friend) is that he had heard the pin on the barrel for typical AR15 is facing up but on the ATRS the pin is facing down?
I never met a gun I did not like!
Yes they will fit. No the index pin doesn’t face down.Originally Posted by SKScanuck
CGN Weekly Schedule
Monday: Can't access the EE! Tuesday: Non-restricted rifles like AR-15? Wednesday: Difference between 223 and 556? Thursday: 9 or 45? Friday: Bear Defense thread Saturday: Why is this prohibited? Sunday: Zombie thread
...
Last edited by jiffx2781; 05-18-2020 at 12:35 PM.
"Arguing with idiots is like playing chess with a pigeon..... No matter how good you are, the bird is going to s#!t on the board and strut around like it won anyway."
Thanks guys!
I never met a gun I did not like!
I know myself and a few others were asking about hand guards that fit a 0.936 gas block. I ended up going with an Odin Works RAGNA 17.5" hand guard along with an IBI 19" R/S profile barrel with the low profile 0.936" Gas Block. As I don't have my upper and lower yet (run 3) I can't be 100%. However when I put the hand guard over top the barrel and it appears to be horizontal inside, there is a decent amount of clearance around the gas block still. The hand guard is supposed to have a 1.35" ID.
^ does anyone know how those anti-rotation tabs will affect mounting the Ragna?
Good find btw.
"He who dares not offend, cannot be honest."
- Thomas Paine
"Oppression maketh a wise man mad"
I didn't think of the tabs, hopefully its not too much of an issue. Im guessing I may have to cut them down a bit.
What’s the total height of your GB? What brand is it?
All the GBs I’ve looked at , measures 1.46 total height.
I thought you would need a hand guard with an inside diameter ,a little more than 1.36
I measured it and it is 1.46 pretty much. It's not adjustable so it is symmetrical and there is no oblong protrusion on one side to hit the guard. I had been trying to do some research on guards that fit and came across a video on you tube where a fellow used this guard with a 0.936" block with no touching so figured I'd try it. On plus is 17.5" which I wanted a guard to go near barrel length and cover the GB.
Posting Permissions
Reply With Quote
