WK-180c alternative handguards

Thread: WK-180c alternative handguards

Tags: None

  1. True North Arms Corp's Avatar

    True North Arms Corp said: 09-27-2018 08:54 AM

    WK-180c alternative handguards

    We're getting a lot of questions about replacement WK-180c handguards. These two handguards are tested to fit over the WK's larger gas block.

    Some folks are getting away with sliding these right onto the WK's barrel nut. For optimal rigidity you might need to use the barrel nut that comes with the handguard.

    Lots of colour and length options up to 17".


    Super M-LOK Handguard

    https://truenortharms.com/ar15_defau...y-install.html





    Super Keymod Handguard (Easy-Install)

    https://truenortharms.com/ar15_defau...y-install.html

    True North Arms Corp.
    Website truenortharms.com
    Email info@truenortharms.com
    Instagram truenortharms
     

  2. diablo_man's Avatar

    diablo_man said: 01-10-2019 03:45 AM
    ...
    Last edited by diablo_man; 08-14-2019 at 06:43 PM.
     

  3. neoconfection's Avatar

    neoconfection said: 01-10-2019 10:19 AM
    Quote Originally Posted by diablo_man View Post
    Any chance of these coming in a dark Green(foliage or OD green)?
    I know it's not quite the question you asked, but these rails are very rattle-can friendly
     

  4. Baitcaster's Avatar

    Baitcaster said: 01-10-2019 10:50 AM
    I really, really like the stock handguard. I just wish it was a couple of inches longer. Any chance Wolverine/Kodiak will offer a longer version of the stock handguard as an aftermarket item in the future?
     

  5. Haywire1's Avatar

    Haywire1 said: 01-10-2019 09:38 PM
    Quote Originally Posted by Baitcaster View Post
    I really, really like the stock handguard. I just wish it was a couple of inches longer. Any chance Wolverine/Kodiak will offer a longer version of the stock handguard as an aftermarket item in the future?
    Should probably ask that in Wolverines section....
    "A fear of weapons is a sign of retarded sexual and emotional maturity."
    - Sigmund Freud
     

  6. The_Silencer said: 01-11-2019 01:31 AM
    Has anyone actually fitted an aftermarket barrel nut? My Wk180c's barrel nut threads are completely out of spec and I'm too afraid of cross threading the receiver threads.
     

  7. AFC22's Avatar

    AFC22 said: 01-18-2019 06:15 PM
    Anyone successfully removed the factory hand guard?
     

  8. Itr452 said: 01-18-2019 07:17 PM
    Quote Originally Posted by AFC22 View Post
    Anyone successfully removed the factory hand guard?
    Someone posted in the wolverine vendor forum recently ..mangled bolts but he took it off
     

  9. Paul_T's Avatar

    Paul_T said: 01-18-2019 07:39 PM
    Quote Originally Posted by AFC22 View Post
    Anyone successfully removed the factory hand guard?
    Yes, no problems. 3mm allen. Some got shipped with blue loctite on the screws (my early rifle did).

    Heat them up a bit with a heat gun or hair dryer if they won't move.
    Last edited by Paul_T; 01-18-2019 at 07:46 PM.
    "No matter where you go - there you are"
     

  10. The_Silencer said: 01-19-2019 03:10 PM
    Has anyone successfully change out the barrel nut?