Here's an example done by Wolverine with our handguard and fake suppressor:
Here's an example done by Wolverine with our handguard and fake suppressor:
True North Arms Corp.
Website truenortharms.com
Email info@truenortharms.com
Instagram truenortharms
nice! thanks for uploading that pic! ill be ordering a 15" in black very soon!
All bolts came out but 1......gerrrrr. Its stripped. How the heck do you get it off? Was thinking of JB welding the 3mm key in the bolt. Any other solutions?
“Hard times create strong men. Strong men create good times. Good times create weak men. And, weak men create hard times.” G. Michael Hopf
Cut a slot and use a flathead screwdriver. Same thing happened to me. I used my Dremel for it, easy peasy. Just be careful not to damage the original handguard when you're doing your cut, if you plan on keeping it that is.
17" looks better. Those exta inches make a difference... I can be a real size queen sometimes.
I did the 15" on mine with the reverse fake suppressor, looks awesome and just the right amount of overlap between the two. Was extremely easy to install, just needed a large screw driver to spread the new one enough to fit around the original barrel nut and then tighten. I sent the results to TNA, they might be able to post it.
Bring it back! Any chance of seeing 15" in black anytime soon...?
True North Arms Corp.
Website truenortharms.com
Email info@truenortharms.com
Instagram truenortharms