Anyone have issues with gen3 pmags?
I have noticed the mounting system prevents many trigger option from being installed. My choice was a HyperFire which is unfortunately on the no go list.
CCFR — CSSA
That may work however the idea of manipulating the rear pin in such a fashion will lead to future problems.
CCFR — CSSA
...
Last edited by jiffx2781; 05-18-2020 at 10:31 AM.
"Arguing with idiots is like playing chess with a pigeon..... No matter how good you are, the bird is going to s#!t on the board and strut around like it won anyway."
Tried my MS today. It’s having issues with feeding and not locking bolt to rear. The tolerance seems pretty tight on the bolt catch where it meets the face of the bolt. Some mags choked on every round or 2nd round. As it got broke in seems to run better. Went 3 full mags with not issue. Then having intermittent issues. My question is obviously I’ll chwck gas block alignment bc it seems undergassed. But I’m running a normal adjustable stock with carbine buffer spring and weight. Could this also be causing? Should i switch to rifle length spring and weight ? I’m
"Victory favours the prepared"
Mine ran excellent with a brownells carbine buffer and spring. 20 inch barrel and mid length tube.
I’d check the gas block