Ive read in this thread that lapping the receiver is not required and is not recommended by ATRS.
For those that have completed builds how does the receiver to barrel fit seem and has anyone needed to lap?
Hi all this is my first build and so far all is going well except my bolt catch retaining pin won’t seat flush, am I using the wrong pin or is it a part of the design? Other pics I’ve seen of finished builds have the pin being flush
“I felt a great disturbance in the Force. As if millions of voices suddenly cried out in terror and were suddenly silenced.” — Obi-Wan Kenobi
I just ordered some stainless 0.001 stock from Amazon.
I probably got enough for 100 builds but its not expensive.
Been reading up on it a little and it certainly seems like a better bet than just Loctite to bridge the gap (which is what a lot of folks seemed to be using)
I want you to be pleased with your purchase, so do not hesitate one bit to ask questions before purchase! If we do decide to go forward with payment, I assume that you are satisfied with all info provided before payment. This is a polite as-is disclaimer.
I ship at least once a week on my day off.
Anyone happen the know the size of the ball bearing early lowers use for the safety? The guy I sold mine to lost it swapping safety levers...
I’m pretty sure it’s a 1/8” ball