Are you making them "factory" size or can you create batches of over-sized pins to take out some of the slop between upper and lowers (Note - on my earlier version I could only remove some of the play due to the size difference between upper and lower pivot pin hole sizes).
Would have had to ream both holes (destroying the factory finish) in order to remove all the slop.
L
--------------------------------------------------
"If sense is so common ..... why is it in such short supply?"
Delete
Last edited by wd113; 05-08-2020 at 04:51 AM.
CSSA / CCFR / CPC (almost to the point of walking away)
I'll take one. Want my $20 now or after production?
"Arguing with idiots is like playing chess with a pigeon..... No matter how good you are, the bird is going to s#!t on the board and strut around like it won anyway."
I'd be in for some that are slightly oversized. The receiver play on my WK is getting bad.
Im in. Those e clips. Gots. To. Go.
I’ll take 2 please
Only the dead have seen the end of war. PLATO
C.C.F.R member
I'd take 2
"No matter where you go - there you are"