Any idea where to get a BCG for it?
Last edited by SigWig; 03-11-2019 at 11:55 PM.
If you could find a handguard for me(any colour), I’ll take it. I have a 14.5 inch mr223, I really don’t want change handguard everytime!
Same handguard length
Only a few left, this might be the only chance to buy HK MR parts before 2020.
Durham I'm curious if you know or could find out if it will fit the 1st gen Mr 223? The receiver pin hole or holes I believe are different? Also is there a notch on the top front of the pic rail to accept a 1st gen handguard?
Handguard included? Irons?