How many guys have done the mod for the rear take down pin? And is it worth it? If it is can we have that done before our next lowers ship?
How many guys have done the mod for the rear take down pin? And is it worth it? If it is can we have that done before our next lowers ship?
That is correct, however, I’m sure if someone with the thicker hook, could easily remove a small amount of material to accommodate the couple of triggers that don’t fit.
The hook is very meaty( for lack of a better word) and removing a small amount from the bottom of it should be fine.
But it may void warranty
No they will not be. They will be referred to as Gen 1.11427B.
Gen 2 is early in the theoretical planning stages, looking into an alloy of Rarified Energon and cybernucleic acid, offering a potential 98% weight savings for hunters as the gun will literally carry itself. Have to wait for NASA to get back to us to see how the supply is but it's safe to assume it'll be very, very expensive.
And yes. You were just trolled. There are no generations, just modern sporters.
Alberta Tactical Rifle Supply
Canada's Premier Precision Rifle Manufacturer
Please email all inquiries to info@albertatacticalrifle.com NOT through PMs
The Province of Alberta has been suffering for the last 30 plus years with an EAST infection
http://www.albertatacticalrifle.com/
Long Distance is BETTER than being there
This should never be a warranty problem. Assuming someone does not go full blown retard with the power tools that is. To put an angle on the hook station should not take more than a few passes with a file. But do keep in mind warranty expressly does not cover "stupid" and we all know there are guys out there that should under no circumstances be allowed to work with anything more complicated than a spork.
Alberta Tactical Rifle Supply
Canada's Premier Precision Rifle Manufacturer
Please email all inquiries to info@albertatacticalrifle.com NOT through PMs
The Province of Alberta has been suffering for the last 30 plus years with an EAST infection
http://www.albertatacticalrifle.com/
Long Distance is BETTER than being there
Hrm...really thinking about building a M16A4 clone on one of these sets.
"If everyone is thinking alike, someone isn't thinking."- General George Patton Jr, NFA, CSSA and NRA Member
I am in the last 80% of run 2 for a complete set. Have depression because this may be a 2020 season rig and dust collecting on all the bits in waiting. However, as I have said here before, all good things to those who wait.