CanadianGunNutz.com logo, Firearms News and Classifieds in Canada

Page 6 of 6 FirstFirst 123456
Results 51 to 58 of 58

Thread: LAR-15 223-556 Stainless 10/30 Round pistol Magazine in Canada 23.94USD

  1. #51
    Super GunNutz Razer's Avatar
    Join Date
    Jul 2011
    Location
    GTA, Ontario
    Posts
    480
    So can you seat them 'decently' on a close bolt?

  2. #52
    CGN Regular crasheralex's Avatar
    Join Date
    Aug 2014
    Location
    Cambridge, On
    Posts
    768
    Why the rivet if they're crimped?
    "Take a deep breath, and find your balls..."

  3. #53
    CGN Ultra frequent flyer Sinasta's Avatar
    Join Date
    Jun 2005
    Location
    At The End Of The World
    Posts
    3,448
    Quote Originally Posted by Razer View Post
    So can you seat them 'decently' on a close bolt?
    Sold out and only two people bothered to report back how they work...

  4. #54
    CGN Regular Ntloukas's Avatar
    Join Date
    Sep 2011
    Location
    Vancouver BC
    Posts
    229
    They ran flawlessly in my AR and MS.

  5. #55
    CGN Ultra frequent flyer Sinasta's Avatar
    Join Date
    Jun 2005
    Location
    At The End Of The World
    Posts
    3,448
    Quote Originally Posted by Ntloukas View Post
    They ran flawlessly in my AR and MS.
    You can fit them in a closed bolt without much force?

  6. #56
    CGN Regular Ntloukas's Avatar
    Join Date
    Sep 2011
    Location
    Vancouver BC
    Posts
    229
    Quote Originally Posted by Sinasta View Post
    You can fit them in a closed bolt without much force?
    I had them fully loaded with no issues

  7. #57
    Member
    Join Date
    Jul 2018
    Posts
    66
    really? at 10 i had to slap it or hard insert.

  8. #58
    CGN Ultra frequent flyer BattleRife's Avatar
    Join Date
    Mar 2004
    Location
    of No Fixed Address
    Posts
    2,677
    Quote Originally Posted by Sinasta View Post
    Sold out and only two people bothered to report back how they work...
    I didn't get any from this batch, but I did get one from an earlier batch, last autumn.

    It was a little difficult to get the 10th round in the mag at all, and it latching the mag into the rifle on a closed bolt would have required an irresponsible amount of force.

    However, I found it was entirely possible to strip the magazine to modify the follower. My baseplate was not riveted, it came off normally, and I was able to release the mag spring with a pair of needle nosed pliers. From there, some patient wriggling and judicious pressure was enough to work the follower past the crimps.

    I removed about 1mm of material from the bottom of the follower at each corner. I then reinstalled the spring in the follower, reworked the follower into the mag body (reinstallation required a little more patience than removal, due to the spring being on the follower), and it holds a perfect 10.5 rounds, now.
    --BattleRife

    _____________________________________________
    Anybody who says "There is no such thing as a stupid question"
    has not spent much time on the internet.

Page 6 of 6 FirstFirst 123456

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •