So can you seat them 'decently' on a close bolt?
So can you seat them 'decently' on a close bolt?
Check other started threads for combo deals
Why the rivet if they're crimped?
"Take a deep breath, and find your balls..."
.....
Last edited by Ntloukas; 08-14-2022 at 11:45 PM.
......
Last edited by Ntloukas; 08-14-2022 at 11:44 PM.
really? at 10 i had to slap it or hard insert.
I didn't get any from this batch, but I did get one from an earlier batch, last autumn.
It was a little difficult to get the 10th round in the mag at all, and it latching the mag into the rifle on a closed bolt would have required an irresponsible amount of force.
However, I found it was entirely possible to strip the magazine to modify the follower. My baseplate was not riveted, it came off normally, and I was able to release the mag spring with a pair of needle nosed pliers. From there, some patient wriggling and judicious pressure was enough to work the follower past the crimps.
I removed about 1mm of material from the bottom of the follower at each corner. I then reinstalled the spring in the follower, reworked the follower into the mag body (reinstallation required a little more patience than removal, due to the spring being on the follower), and it holds a perfect 10.5 rounds, now.
--BattleRife
_____________________________________________
Anybody who says "There is no such thing as a stupid question"
has not spent much time on the internet.
Ever getting these again? They're not on your sight anymore...
Yes, we have them all in stock.
Here is the link.
https://www.irunguns.ca/product.php?...c&category=all
Flat rate shipping to Canada is 25.00USD on all accessory and ammunition orders regardless of quantities ordered. Firearms are exported to Canada at a flat rate of 25.00USD per firearm.
The IRUNGUNS Team
www.irunguns.ca
www.irunguns.com