hi Simon, not to nag, but did you get a chance to contact the manufacturer or the importer about the bolt material?
“... and they who cried: “Appease, Appease!” are hanged by men they tried to please.”
no we have not got an answer.
feel free to contact them if you have an issue or a question, we have only 3 people on staff at the retail shop and its all we can do to keep on top of things right now.
i,m in the shop now since 7am building guns and filling orders.
here you go
https://www.triggerwholesale.com/Contact.htm
thank you, i will send them a message and see what they say
“... and they who cried: “Appease, Appease!” are hanged by men they tried to please.”
Wait till you have your gun then submit serial # with request..
Otherwise I think you may not get much of a answer?? .02
Alrighty so finally got out shooting it at farm. 1 st shot magpie down , with my boy so that was cool. Sighted in for slugs like 20 ish yards
Anyhow gun won't rack back empty or cycle , need help here Simon. I checked the O rings on those two rods , there fine. I tightened up more and also break cleaned out the receiver thinking it might not like so much Lube. No luck. Tried a 3" shell to see if it would lock back. Nope.
Putting back together I noticed the rotating bolt has like zero tension .... is that supposed to be like that ? And doing that if the bolt locks back a certain way to re install I'm not sure if I did that right ?
Also the roll pin for bolt release fell out 2nd / mercy shot on magpie how I managed to be watching that idk. I mushroomed it etc etc
Anyhow how we fix this ? Send back ? Bigger o ring on those things ? Not much fun having a semi semi. Thanks. Anyone else chime in too please if got any ideas
Actually on the contact link that Simon provided they do ask for make, model and serial #
delete
Last edited by JeffMan; 05-01-2020 at 06:04 PM.