Turknelli M4 is HERE AT LAST!!!! TAC 12 BY Trigger wholesale!!!!

[badboybeeson]

Attachment 307214Attachment 307214

[B]

So how is the tube blocked? Sounds like whatever the actual capacity is it isn't 5.9 3" shells so I'd like to be able to fix that. If it's full of epoxy or other nonsense I have seen in the past that will be a deal killer.
Same as the odell unit small crimps on the mag tube that can be pushed out

[badboybeeson]

³
Yes at some point . But have only ever done rem 87o ans mossy 930 .
So need to play with it first
Best to go wirh Tac Ord if u want it done right away
Casey does good work

[B]

Thanks BBB, sounds like I will be able to figure it out at least. I assume tolerances are close enough that a Benelli tube would fit?

[Junction]

Do we have a definitive answer on how many 2.75" shells will fit in the tube?

Thanks!

[Wal-Mart Greeter]

So how is the tube blocked? Sounds like whatever the actual capacity is it isn't 5.9 3" shells so I'd like to be able to fix that. If it's full of epoxy or other nonsense I have seen in the past that will be a deal killer.
Same as the odell unit small crimps on the mag tube that can be pushed out

Speaking from experience, you won't be "pushing out" the ribs on those mag tubes. They are significant. I had to use an 8" round file to remove 98% of the ribs then finish it smooth by pounding a socket through. You won't have any luck without removing a bunch of material first. Also the muzzle end of the mag tube is tapered and to get any tools in there you will have to take a couple threads off the end with a bench grinder first...

Not a HUGE job but you definitely need a free hour and some commitment!

[badboybeeson]

Speaking from experience, you won't be "pushing out" the ribs on those mag tubes. They are significant. I had to use an 8" round file to remove 98% of the ribs then finish it smooth by pounding a socket through. You won't have any luck without removing a bunch of material first. Also the muzzle end of the mag tube is tapered and to get any tools in there you will have to take a couple threads off the end with a bench grinder first...

Not a HUGE job but you definitely need a free hour and some commitment!

Worked on the gun at home late last night.
This gun ia quite alot like the odell gun just more refind.
The finish is mi h better both on the anodizing and the steel parts
The mag tube just unthreads.
It is not tapered so it ia eaay to work on.
It does have the small rib on the mag tube.
But has nothing else blocking it.
It does not quite hold 6rds of 2.75
So a mod to the tube will be needed for you to get 5rds of 3 inch.
You will then need to block the tube as it will then hold to many rounds.

[wolf300H&H]

Stupid question. X2

This will fire slugs right ? Just have no chokes in correct ?

And easy peezy to install match saver ?

[badboybeeson]

To shoot slugs it comea with a cly bore choke you can also shoot most slugs out of a mod choke with no issue.
Match saver is dead easy. You juat lined it up on the handguard where u want it and drill 2 small holes ans use the provided hardwear.
Their is alot of videos on line showinf how too.

[Foxer2373]

Stupid question. X2

This will fire slugs right ? Just have no chokes in correct ?

And easy peezy to install match saver ?

Never fire a shotgun without a choke in it... good way to make sure it will never take chokes again!