We will be getting the screws from UPS later on today. We will start shipping them tomorrow morning.
I dont think you know how to read. And BLS is sending it to my house directly
However, if your retailer does not have them in stock, please contact us at warehouse@blsolutions.ca, and we will send one to you directly.
We apologize for the inconvenience!
Save Hong Kong!
Dont have high hopes. It doesnt do much. I actually put a set screw behind the trigger plate, that worked alot better than that OE screw hole as it eliminated ALL pretravel.
I think i am going to go start a mod thread in rimfire section.
So let me explain why this didnt perform as i expected.
It createa a preload on the sear bow, which is separate from the trigger bow, so what you get is a shorten break so to speak. Here is the dilemma, the trigger bow is separate in this whole operation, what this translate to is that all the pre travel is still there then the trigger stacks and breaks.
By removing the slack in the trigger plate amd polishing, it performs better than using the supplied trigger adjustment screw
Last edited by sky52; 10-19-2019 at 12:32 PM.
Save Hong Kong!