I think there should be a sticky about that damn spring lol
I think there should be a sticky about that damn spring lol
Thank you Stanislav Petrov..... every living thing thanks you.
I had seen the video on the 522 before I got mine so I always paid attention to the spring. So far it has not fallen out once, but I will probably keep a couple of those bic’s around just for good measure. Thanks for figuring out such an easy to source replacement!
So this spring will pop out of the gun during the recommended disassembly for cleaning?
I just did that and don't recall seeing a spring. I'll check out the video.
CSSA/CCFR Member • An unjust law, is no law at all. ― Martin Luther (1483-1546)
There may be times when we are powerless to prevent injustice, but there must never be a time when we fail to protest. ― Elie Wiesel
That dumb spring. I will suggest that as soon as you pull the bolt grab that spring and put it in a safe place. It always falls out when ya don’t notice
This post was a life saver. Happened to have a big pencil in the house
My spring popped out as well. I almost lost it. looked everywhere. Finally found in inside the gun stuck to the side. Was a very happy moment. My son was looking at me like whys dad going so nuts lol. I think im gonna put a lil piece of black electrical tape over it so it doesn't go missing again. hope that helps me. Good to hear about the bic tho if it does go missing.
Don't miss... I won't...
I'm in the same dilemma, except mine must have popped out after about 100 rds at the range. Slide locked back, wouldn't charge. Had to use a small tool to push the lever down while holding the bolt back to get it to go forward. No doubt it fell out of the mag well and ended up on the floor.
UPDATE: By sheer luck, we had a bic mech pencil. Did as you guys said, works like a charm !!! Thanks all !
Last edited by Ardrossin; 12-03-2019 at 03:11 PM. Reason: Update
Just lost my spring, damnit, thx for this post pencil on order