Is it going to have as many issues and be as awful as the WK-180C?
So the changes I can see are:
-rear charging handle which closes up the back half of the gun where the old charging handle was. also eliminates the left openings on the gun and with the bolt release gives closer to ar15 controls.
-brass deflector
-magpul furniture
-beveled the top of the receiver which not only takes away from the 180s naturally boxy appearance, also frees up the top rail for things that had issues fitting like qd latches, eotech, 45 offsets etc. this is a huge plus to me.
-trigger is softer was mentioned
-Handguard is much longer and has a more open triangly look, connects at 3/9 instead of on 45 degree
I cant tell if the entire top rail is higher or if its just the new angles of the hand guard/receiver that make it look like this. I'm sure theyd keep it to AR15 spec for optics
good point, even just the little build outs with holes so we could add them ourselves.
Is the handguard replaceable with after market ones? Ar15 handguards or 308 low/high profile?
Looks interesting...Now I'm going to have learn about the issues on the predecessor.
Last edited by Tillsonburg Gun Shop; 11-17-2019 at 02:48 PM.
So NO wk181c then!?!?!
CSSA CCFR PROUD MEMBER
"Sleep in bliss Pops"!!!!!!
X2^^^^
i want to blast some 7.62x39.
Too bad it wasn’t in 7.62x39