Will you guys be selling parts kits for these?
Save me from having to buy two more, haha!
Is there is any specific reason the design was changed from 3 hex screws to 2 to hold the handguard in place? Also wondering the same as mentioned above, if a spacer was used do we have any options to get it swapped for a proper fitting handguard?
CSSA/NFA Member / Silverdale Member
Anyone know if there is an upgrade bolt catch/release available or coming? Thanks
do you sell MCR uppers and other parts ???
Received my WS-MCR recently and I am shocked at how difficult it is to remove the front and rear takedown pins. I needed to use a punch and an armors hammer to lightly tap them out, using a pen with as much pressure as I could would not pop them. Putting them back in proved to be even more challenging. In addition to that, the castle nut was loose enough to turn with the fingers.
I have tools to work on my firearms, but realizing many don't, this would be quite disappointing.
Any comments from other users?
My upper and lower are stiff but are starting to separate easier ...