Does the c-clip need to be installed on my friends dust port rod ?
Modern Sporter
V7 dust cover and rod.
Came with c clip pre installed. i heard that it is preventing the rod to be fully seated.
Does the c-clip need to be installed on my friends dust port rod ?
Modern Sporter
V7 dust cover and rod.
Came with c clip pre installed. i heard that it is preventing the rod to be fully seated.
You have enemies? Good. That means you’ve stood up for something, sometime in your life - W.C.
Member NFA
I had the aero precision rod that comes with the c clamp attached as well and I had to cut off a piece and remove the c clamp to make it fit
“I felt a great disturbance in the Force. As if millions of voices suddenly cried out in terror and were suddenly silenced.” — Obi-Wan Kenobi
Yup, depending on the handguard it may be too long.
Its way too long with the c-clip there.....I can't seat the rod in the receiving mounting hole with it there.
Its my first build so I am just concerned I would be doing something wrong. I know its just a dust cover, probably won't make anything blow up, just don't want to miss something obvious. All the install vids I could find are for typical AR builds and they all show an easy install with the c-clip ......but this isn't an AR, so I'm unsure if it's needed or not.
The handguard is a MRA V1
You have enemies? Good. That means you’ve stood up for something, sometime in your life - W.C.
Member NFA
I didnt use the c-clip Handguard stops the rod from backing out anyways.
Upper assembled .....now the lower and all those fun little springs and pins ; )
You have enemies? Good. That means you’ve stood up for something, sometime in your life - W.C.
Member NFA