Hopefully that was a worst-case estimate and we see them a lot sooner.Originally Posted by Geoff B
Think of the howling we'd hear from this crowd if it slipped to Labour Day, eh?
|
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
Hopefully that was a worst-case estimate and we see them a lot sooner.
Think of the howling we'd hear from this crowd if it slipped to Labour Day, eh?
Also curious about this question.
GREASY CIVI Black Rifle Shooter
Member: BDHACC, OSPE, PEO, CSSA, CCFR, Project Mapleseed, CRPS, OSA
I didn't notice if anyone had asked regarding extra uppers, will spare uppers be available?
I'm assuming the barrel can be installed using Barrel Blocks, can someone confirm this? Looking at the set I see no reason why this won't assemble exactly the same way as the Rifle I'm rading for parts.
Last edited by Maple Ridge Armourer; 06-29-2020 at 12:28 PM.
There's a big difference between kneeling down, and bending over. FZ
Yes uppers will be available in September and onward.
Yes you can use a Barrel Block to assemble.
Yes we are on schedule.
Pitter patter.....
a little question for the 7.62x39. which magazines will work?
I would assume the same ones that work with the AR-15? Take a look at the XCR pistol mags. 10 rounds of 7.62x39 joy
Apologies in advance if these are dumb questions, I'm a noob when it comes to the world of AR-type builds.
Would it be viable/possible to go for a shortie 6.5 Creedmoor build with this?
I think the 10 round 308 mags could be used for 6.5 cm?
Thanks
Member of the CCFR - ΜΟΛΩΝ ΛΑΒΕ
You will not be able to use this V1-B, as it is chambered and has an ejection port sized for 556 based cartridges. I'm not sure if I'm remembering right, but I believe MRA will be developing a 308 chambered firearm with the same concept, but that is not yet available.
Posting Permissions
