Looking forward to shooting my mostly MRA rifle.
Looking forward to shooting my mostly MRA rifle.
Looking good! Can't wait for a range report.
Looks great guys! Can you confirm if rear of receivers geometry is std so I can use my law tactical folder? Would have to thread into the upper I guess?? Does bcg have the same ID hole at rear? Thanks!
Last edited by Maple Ridge Armourer; 07-06-2020 at 02:51 PM.
(1) MRA Rebegade Barrel Gas Journal Seal .750" diameter (allows the use of various aftermarket barrels with a gas port)
What happens if you dont cover the gas port? My journal is .625
Looks great.
If a 308 version is in the works, have you thought of a small frame and high DPMS tang/threads.
Gas will leak out of it. If it is inside the handguards it would make everything carbon covered and you would need to not hold right there. You can also just put a gasblock on and insert the gas tube upside down. It would do the same thing.
If its upside down it wont clear my handguard, I guess just put it on backwards/reverse? JB Weld the hole? but then thats permanent
MRA pls make a .625 seal
Last edited by Suchee; 07-04-2020 at 10:58 PM.
You can run a standard gas block backwards and block the port in the barrel.
Hi MRA,
Looks like I scored the last pre-sale receiver set.
Can I please ask the length of the receiver?
Trying to figure out minimum barrel length required to remain non-restricted.
Thanks!