The bolt catch retaining screw comes with the receiver set. I used a DPMS LPK and other than trimming the front takedown spring as mentioned, had no issues during assembly.
CSSA and CCFR Member
Anyone have issues with tight magwells?
“I spent most of my dough on guns, gals, and gas, and the rest I wasted.”
-me, with apologies to Elmore Leonard
Mine is together and functioning but will not hold open with magpul magazines. Is this normal - steel mags works fine. And I did keep the bolt catch screw loosend back a few turns as suggested above.
Edit - I backed it out alot more and now it seems to be working better, should I put on loktite as it seems like it may back out.
Last edited by sbe; 08-17-2020 at 12:32 AM.
I just want to comment on the reciever set. Everything was interchangeable. However, the dust cover need the round rod that uses the c clip (The C clip wouldnt be needed).
Only problem i have is the bolt catch. It works with an empty mag. But if I do this manually, i would need to pull all the way back, very very hard.
Apologies, I don't have enough time to go through this entire thread. Is this receiver set still being produced?
I may not be smart a Man... But I'm smart enough to know Criminals don't Obey Gun Laws. ΜΟΛΩΝ ΛΑΒΕ