Have you guys thought about making a aluminum rail delete kit for this rifle, or maybe one that deletes most the rail but leaves like 3-4 pic slots to mount an optic. I think you guys would make a killing on this.
Have you guys thought about making a aluminum rail delete kit for this rifle, or maybe one that deletes most the rail but leaves like 3-4 pic slots to mount an optic. I think you guys would make a killing on this.
Are you asking to make a one piece unit for the top of the receiver ? I do notice that the 'MP-5' kit from the USA doesn't quite cover the front one inch or so of the top. Looks kinda dumb where it just ends. Let me mull it over and see what the interest / cost for this would be.
Cheers,
Leigh
Dlask Arms Corp.
www.dlaskarms.com
“Hard times create strong men. Strong men create good times. Good times create weak men. And, weak men create hard times.”
Ya, basically taking the two plastic rails that are attached on top and making it’s a one piece of aluminum with either a couple pic rails to attach an optic, or just a flat version with the a rib to attach the hk metal site. I don’t really trust mounting an optic to a plastic rail. Have it anodized black. I think you would make a killing. All these guys are selling tons with 3D printed plastic. I’d rather a stronger version. Thanks for responding back to this thread.
And yes Dlask, a one piece for the top of the reciever
I'd be in for one
"No matter where you go - there you are"