How many of these are cross compatible with the MCR? AR standard parts aside, what about gas blocks and other bits?
Any intent to bring in the MCR as well? Or just the WK-180?
How many of these are cross compatible with the MCR? AR standard parts aside, what about gas blocks and other bits?
Any intent to bring in the MCR as well? Or just the WK-180?
Looking down the barrel, of 1984...
Foxtrot Uniform Charlie Foxtrot Oscar.
It's too late to work within the system, but too early to shoot the bastards. - Claire Wolfe
Is there any of the bolt carrier with a new threaded handle, I have an old one with the not so good magnet. Thanks!
A common and necessary upgrade is the extractor spring. BCM makes a cheap kit to upgrade it. If you don’t already stock that, it’s worth adding to your inventory.
TNA already has a great selection of standard and extra power extractor springs as well as rubber inserts and o-rings
True North Arms Corp.
Website truenortharms.com
Email info@truenortharms.com
Instagram truenortharms
True North Arms Corp.
Website truenortharms.com
Email info@truenortharms.com
Instagram truenortharms
Would it be possible to put together a build kit that guys could transfer compatible AR-15 parts onto? I’m thinking upper/lower receiver bolt carrier and any WK-180 specific parts.
This is awesome. Thanks again for everything you guys do. I think I'd even buy my groceries from you guys if I had the option.
Is this firing retention pin mentioned as compatible with the WK-180C also compatible for the WS-MCR? Adriel the Hunting Gear Guy mentioned in his review of the WS-MCR that his rifle used a prone-to-fail roll pin as the retaining pin; others on the forum have noted this as well. If this is a suitable replacement, MCR users may want to purchase multiples, as your site recommends changing the pin every ten times its removed.