How about making mid gas length piston rods.
How about making mid gas length piston rods.
CCFR — CSSA
So will a wk 7.62 upper work with a 223 mcr lower?
I can understand the forum wishing links to only those vendors that pay for it, as it is a business. I just wish they would allow non-site sponsor vendor links when a vendor doesn't carry a particular product. At least we can mention the non-site sponsor vendor without the post being scrubbed as a compromise :P
The right to buy weapons is the right to be free.
Bureaucracy not an instrument of democratic government but, on the contrary, the worst enemy of freedom and democracy.
If the penalty for a crime is a fine, then that law only applies to the poor.
If a forum vendor provided a mid-length piston for the WK, I would definitely post the link to the forum sponsor vendor's site. As far as I know forum vendors provide replacement carbine and rifle length pistons, but no mid-length piston. If you have a forum vendor who does have a mid-length piston, please post the link, and I will remove the reference to the non-site sponsor vendor.
The right to buy weapons is the right to be free.
Bureaucracy not an instrument of democratic government but, on the contrary, the worst enemy of freedom and democracy.
If the penalty for a crime is a fine, then that law only applies to the poor.
Well, fudge, my apologies, I hadn't looked which subforum I was responding to the post on. TNA, I've redacted my own post, please feel free to include the redaction in the posts from others. Again, my apologies. Also, if you make a carbine piston, and a rifle length piston, a mid length piston would be cool to complete the set