P12
CGN frequent flyer
- Location
- Georgetown
Ok so this might be a crazy idea but I'll ask anyway, can you guys make a Recover type rail system and grips for the Ruger Wrangler and or other revolvers too, something along the lines of what is in this video:
and a little bit more of an explanation of what it is and how it was made in this video:
Unlike the 3D printed one in the video, it would be great if it could be put on the gun without having to remove parts, just two sides that clamp on from both sides and are secured with screws, or something along those lines.
With the popularity of the Ruger Wrangler and other budget-minded revolvers, this could be a fun and inexpensive way to upgrade a nice little gun and make it look totally different.
I don't have a 3D printer and I would rather buy something that is professionally made.
Would anybody else be interested in this or am I the only one?
and a little bit more of an explanation of what it is and how it was made in this video:
Unlike the 3D printed one in the video, it would be great if it could be put on the gun without having to remove parts, just two sides that clamp on from both sides and are secured with screws, or something along those lines.
With the popularity of the Ruger Wrangler and other budget-minded revolvers, this could be a fun and inexpensive way to upgrade a nice little gun and make it look totally different.
I don't have a 3D printer and I would rather buy something that is professionally made.
Would anybody else be interested in this or am I the only one?