CanadianGunNutz.com logo, Firearms News and Classifieds in Canada

Results 1 to 2 of 2

Thread: Deleted

  1. #1
    Member Tko47's Avatar
    Join Date
    Dec 2016
    Posts
    41

    Deleted

    Deleted
    Last edited by Tko47; 06-04-2021 at 09:29 PM.

  2. #2
    CGN frequent flyer SDC's Avatar
    Join Date
    Mar 2004
    Location
    Ottawa, Ontario
    Posts
    1,046
    A machinist's trick to work around a loose pin (other than machining a completely new pin) is to use a almost-closed vice to lay the pin in, then use a cold chisel to strike 3 or 4 longitudinal grooves in the pin. You may need to press the pin back in with a vice again, but that should stop it from walking out.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •