-
Member
Last edited by Tko47; 06-04-2021 at 09:29 PM.
-
CGN frequent flyer
A machinist's trick to work around a loose pin (other than machining a completely new pin) is to use a almost-closed vice to lay the pin in, then use a cold chisel to strike 3 or 4 longitudinal grooves in the pin. You may need to press the pin back in with a vice again, but that should stop it from walking out.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules