Page 6 of 6 FirstFirst 123456
Results 51 to 55 of 55

Thread: BnT AG APC-9 Non-restricted in stock

  1. #51
    CGN Ultra frequent flyer rommelrommel's Avatar
    Join Date
    May 2007
    Posts
    9,755
    So tempted.

    It’s gotta be a two piece pin, probably a press fit.

  2. #52
    Super GunNutz UR2X3M4ME's Avatar
    Join Date
    Apr 2010
    Location
    Banana Republik of Kebekistan
    Posts
    2,447
    ^^
    Agreed.

    I want that pin out to make the cleaning easier. Somewhere somehow there has to be suitable alternate pins.
    Quote Originally Posted by DrXenon View Post
    What do you need a brake on a 5.56mm firearm for? You should just slip a maxipad under your bra strap to dampen the hellish recoil.
    Spock to Kirk:
    "Logic dictates Captain. If Pro-Gunners are as violent as Anti-Gunners say they are, there would not be any Anti-Gunners left."

  3. #53
    CGN Regular shatthatkilledelvis's Avatar
    Join Date
    May 2009
    Location
    in the bby
    Posts
    518
    Quote Originally Posted by rommelrommel View Post
    So tempted.

    It’s gotta be a two piece pin, probably a press fit.
    It is. It is also 7mm in diameter vs 6mm - which is the standard for all pins on non-canadian bastardized APC/GHM lowers. This means a lower swap is not simple as any stock lower you find/import will have a pin that is 1mm too small. A bushing is needed on the barrel trunnion to reduce the 7mm hole to 6mm.
    Statistics don't lie, but liars use statistics - Aubie Baltin

    No longer a s**t, just a shat...

  4. #54
    CGN Ultra frequent flyer rommelrommel's Avatar
    Join Date
    May 2007
    Posts
    9,755
    Man, what buggers. It was on my mind to ask Bfiles if he could get calipers on it.

  5. #55
    CGN Ultra frequent flyer bfiles's Avatar
    Join Date
    Jul 2009
    Location
    Training in Camp X
    Posts
    11,142
    Quote Originally Posted by shatthatkilledelvis View Post
    It is. It is also 7mm in diameter vs 6mm - which is the standard for all pins on non-canadian bastardized APC/GHM lowers. This means a lower swap is not simple as any stock lower you find/import will have a pin that is 1mm too small. A bushing is needed on the barrel trunnion to reduce the 7mm hole to 6mm.
    Thanks for summing that up

    Quote Originally Posted by rommelrommel View Post
    Man, what buggers. It was on my mind to ask Bfiles if he could get calipers on it.
    All good
    CSSA CCFR PROUD MEMBER
    "Sleep in bliss Pops"!!!!!!

Page 6 of 6 FirstFirst 123456

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •