So tempted.
It’s gotta be a two piece pin, probably a press fit.
So tempted.
It’s gotta be a two piece pin, probably a press fit.
It is. It is also 7mm in diameter vs 6mm - which is the standard for all pins on non-canadian bastardized APC/GHM lowers. This means a lower swap is not simple as any stock lower you find/import will have a pin that is 1mm too small. A bushing is needed on the barrel trunnion to reduce the 7mm hole to 6mm.
Statistics don't lie, but liars use statistics - Aubie Baltin
No longer a s**t, just a shat...
Man, what buggers. It was on my mind to ask Bfiles if he could get calipers on it.