FTP Optics Alpha 3 Red Dot Sight Update

[Fast Toys]

After a long wait, we will have the FTP Optics Alpha 3 Red Dot sight back in stock late next week. These are awesome competition orientated red dot sights that feature a bright, crisp dot and a large window with advanced coated glass.



You can order on our web site: https://fasttoys.net/ca/FTP-Optics-A...-Reflex-Sight/

[Fast Toys]

These will be arriving any day now. You can order online

[Fast Toys]

Just a quick update: A customs delay has resulted in the optics being delayed for arrival at our store until this Friday. We will ship out all orders in the order they came in once we receive our stock.

[Fast Toys]

These are now in stock!

We have ONE 10 MOA optic available if someone wants one. This are normally special order. Give us a call!

[Fast Toys]

We still have the one TEN MOA optic left. If you want it, give us a call!

[aogun]

Just bought one and was delivered super fast . THANK YOU. Question. What plate (and where could I get one) I could use to mount it on G34 MOS in order to co-witness with irons ?

[Fast Toys]

Just bought one and was delivered super fast . THANK YOU. Question. What plate (and where could I get one) I could use to mount it on G34 MOS in order to co-witness with irons ?

I don't know where you could get the plate but you would need one for a Romeo 3 Max.

[aogun]

As a followup - had an issue with your site in mounting it on CANKIK 9sfx. Sight was a bit to big to fit into the cut out (plate 3 had perfect hole alignment but it was .04 in to low). Solved the issue by using to .04 aluminum shims (home made). Works PERFECTLY , sight is on solid - put about 200 rounds through including quick draws from the holster. Very happy. If you want dimensions for the shims - happy to share them with anyone who wants to use the same firearm with your sight. That is until someone manufactures a proper plate. Thanx again for great sight

[Fast Toys]

As a followup - had an issue with your site in mounting it on CANKIK 9sfx. Sight was a bit to big to fit into the cut out (plate 3 had perfect hole alignment but it was .04 in to low). Solved the issue by using to .04 aluminum shims (home made). Works PERFECTLY , sight is on solid - put about 200 rounds through including quick draws from the holster. Very happy. If you want dimensions for the shims - happy to share them with anyone who wants to use the same firearm with your sight. That is until someone manufactures a proper plate. Thanx again for great sight

Thanks for the feedback. So your solution raised the optic to be flush with the slide instead of sitting in the cut?

[aogun]

Top of Canik plates are ALMOST in line with top of the slide (unlike glock 34 - where I tried this originally). the shims went between the plate and the slide raising the plate by .04 (which turned out a bit too much , but i did not have any thinner aluminum plates around. Bottom of the plate is in dome set up __x_/---\_x__. I put 2 shims under the bottom pieces marked as X. the Plate is on SUPER solid and of course sight sits on the plate as it would normally. If you interested - happy to take a few photos and send the to you. Warning, I suck at taking pictures.