Lynx 180B Upper Receiver Info Thread

[SpectreBallistics]

Sorry if this was addressed before, I’m wondering if the pic rail on the receiver would be the exact same height/spec as an AR handguard?
I’m asking because I’m planning on using only irons and I know some 180’s are not compatible height wise with AR handguards.

Thanks

There will be a small mismatch. We opted to have real mil-spec rail so all optics will fit, but that means the receiver rail is a tiny bit higher than the handguard. Iron sights should still work since the mismatch should be within the adjustment range of the sights.

[El_Monty457]

Right hand charge and eject for me.
Looking forward to hearing when these are ready to order.

cheers.

[45C]

Was there an answer to if there’s going to be a rear takedown pin?

[SpectreBallistics]

Was there an answer to if there’s going to be a rear takedown pin?

No pin. Not a standard AR180B part.

[45C]

No pin. Not a standard AR180B part.

Sorry, didn’t know these used all standard AR180B parts.��

[KBCL]

[SpectreBallistics]

Soon. The first run always takes the longest.

[uAJollyRogering]

There will be a small mismatch. We opted to have real mil-spec rail so all optics will fit, but that means the receiver rail is a tiny bit higher than the handguard. Iron sights should still work since the mismatch should be within the adjustment range of the sights.

Will you be making a handguard that matches the rail height?

[Ustauk]

Will you be making a handguard that matches the rail height?

Or get a handguard with an M-Lok top and make or procure MLok rail pieces to add that would be at the right height?

[SpectreBallistics]

Will you be making a handguard that matches the rail height?

Eventually but that is a low priority project. The existing mismatch is tiny and a non-issue.