What's in the Shop This Week

[PR Cook]

Here's something a little different, A full set of rear sight blades for an antique target pistol.





This customer contacted fellow owners all through the states getting measurements from their pistols and had me make him a full set. Giving him, hopefully, a lifetime of options for both close range and far!

[Mik123]

Two thumbs up on your work. Your attention to detail is great to see.

[Ruger007]

Ruger007: I get asked this question often enough that I should probably consider it... A self timing brake is a product I've perceived as already being well supported by several manufacturers. Its claim to fame is that a person can install it on the kitchen table and doesn't need to send his rifle into a smith (personally I think a crush washer accomplishes the same thing). What would you like to see in a self timing brake that isn't already readily available?

I guess a crush washer does do a similar job. But I prefer the versatility of the self timing.

At the range I notice that unless the rifle came with a brake installed the auto indexing seems real popular.

A 30 cal with a proper lock nut rather than a knurled nut would be better.

[PR Cook]

Here's hefty fellow! 500S&W. The customer casts 600grain bullets and wanted the 'ride' tamed down a bit...

[PR Cook]

I've been working on a new product!
Something for those ELR rimfire guys...

[KaneZoR]

Thats bad ass nice work!

Here's hefty fellow! 500S&W. The customer casts 600grain bullets and wanted the 'ride' tamed down a bit...

[PR Cook]

Any ELR 22lr shooters here?
I'm working on developing an Adjustable Picatinny rail with a variety of bottom bases, allowing it to be used across several platforms. This prototype is on a Tikka T1X


This version is adjustable between 0-175MOA in 25MOA increments. Field testing to commence...

[Blygy]

I have been debating just this. 22 LR ELR I mean. It will be nice to have a local source for an adjust le base.

[MilitaryCollectorMark]

Wonder if you can ream out a barrel and do some work on a Reminton 788


Have a project in mind.....

[PR Cook]

PM me, email me at pcook338@gmail.com or give me a shout! (780) 779-6337

Cheers!
Paul.