Quick Grizzly/Kodiak rail question for CanAM or anyone that has one..

Any chance someone can take a photo of the factory top rail on one of these plz?
And/or tell me the following info:

There are 3 screws for the mount. Two screws are closer together, two screws are further apart.
Is the one further apart towards the front, or the back of the receiver???

Thanks in advance!

cheers

The 2 Screws that are closer together are on the rear of the receiver leaving the one furthest apart closest to the front of the receiver.

The latest guns they brought in had different hole placements than the old ones so keep that in mind.

Thanks guys!

I'm not installing them on a Grizzly but rather a Turkish shotgun. But since the rail is a Grizzly rail I may as well drill & tap them in the "right" direction so at least it can be swapped for other Grizzly rails/GRS later on.
Highly improbable that I'd ever do that, but it still comforts me to install the rail in the correct direction

Ack, question #2:

Anyone know what tap size these are?
Doesnt seem to be M3x0.5.. is it M4x0.5??