Good Morning All!
Looking to take out the rear takedown pin of the ATRS gen 2 lower receiver because i bought a Triggertech single stage diamond trigger that requires that to move in order to install trigger housing with retention clasp. Anyone have any ideas? I notice a few comments in othere threads breifly mention it being locktight/JB welded in there but no mention or attempt to remove it
Any ideas?
Thank you
Looking to take out the rear takedown pin of the ATRS gen 2 lower receiver because i bought a Triggertech single stage diamond trigger that requires that to move in order to install trigger housing with retention clasp. Anyone have any ideas? I notice a few comments in othere threads breifly mention it being locktight/JB welded in there but no mention or attempt to remove it
Any ideas?
Thank you