Nothing is permanent with enough money, time, skill, ect.
The wild still lingered in him and the wolf in him merely slept
"It must be poor life that achieves freedom from fear" - Aldo Leopold
Probably end up like sauer 200/202 ssg3000 cut the barrel extension off have threaded by a smith. Then thread on a new pipe. I still don’t understand how you could install it incorrectly, but then the usa is a litigious society.
Some of the aluminum sauer 202 had receiver cracking problems, not unknown with the p94s rim fire either
You misunderstand me.
I have an Alpha in 223 and had it apart yesterday.
The barrel is held in place to the receiver by two hex head cap bolts.
All one needs to do is remove the blob of red epoxy they put on the head of the bolt and the receiver (thread locker for lack of better terminology),
So literally 3 minutes with a small flat head screw driver and a dental pick and voilą - you are off to the races.
What is promising is that even if CZ fail to make good on making caliber conversions, the aftermarket surely can - and there will likely be demand.
Life Member CCFR and CSSA
Posts made by the pseudonym "Beltfed" may not accurately reflect the beliefs and opinions of the Registered User.