![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
Cast will usually have supports, like the two lines on the curve in the ones pictured and machined ones won’t have swooping curves etc and be more square and have a better “luster” in sheen
Usually
Not always with cast vs machined and machined castings make that even worse
But that’s my experience
I’m not a machinist nor a doctor
Mine appears cast as well. Not ideal, but doesn't necessarily mean it will fail either. Hopefully Dlask keeps some extra gas blocks around for future repairs.
Mine was an 11" 5.56 but has been converted to nr, so no factory warranty for me. How much for just a gas block?
Last edited by Cl2; 04-18-2024 at 12:20 AM.
Cheers,
Leigh
Dlask Arms Corp.
www.dlaskarms.com
“Hard times create strong men. Strong men create good times. Good times create weak men. And, weak men create hard times.”
Damn. The parts are in stock but not the install. Did I miss out?
Lol.
How many people swore up and down that the Bren2 was better than the APC.
Anyway, cool to see Canadian manufacturing getting it done.
"He who dares not offend, cannot be honest."
- Thomas Paine
"Oppression maketh a wise man mad"
Well to be fair, this is the only issue so far that has popped up so that's not bad at all. As with all new firearms they will modify the future parts and beef the blocks up or just go with machined billet instead of cast. The B+T GHM9 got modified into THREE entire Gens in only two years iirc so like I said, not unheard of even for the best of companies.
Cheers,
Leigh
Dlask Arms Corp.
www.dlaskarms.com
“Hard times create strong men. Strong men create good times. Good times create weak men. And, weak men create hard times.”