NEA Rem 870 Stock Adapters in stock!

[NeitArms]

Now in stock.

Material :6061 Aluminum
Finish : Type III Hard Anodize

Specs : machined from solid billet, the adapter features two QD sling attachment points. Focus during design was kept on minimizing length of pull and attaining a slim, sleek final product.

http://www.neitarms.com/index.php?ma...index&cPath=23

Bundle with mag follower and save $10


Good job NEA..

[NeitArms]

few left.

[manbearpig]

any chance you could post a photo with one installed on an 870?
interested to see how much drop there is in the stock, and its impossible by just looking at the bare adapter.

[NeitArms]

I'll ask if NEA has one. I'm not sure if they do because they're in Vegas for SHOT too. Maybe they can comment.

[Charles Martel]

any chance you could post a photo with one installed on an 870?
interested to see how much drop there is in the stock, and its impossible by just looking at the bare adapter.

I will post a picture tomorrow. We sold these adapters to several police agencies last week.

[Stevo]

any chance you could post a photo with one installed on an 870?
interested to see how much drop there is in the stock, and its impossible by just looking at the bare adapter.

Here you go. This was waiting for me when I got home yesterday.

The poor fit of the grip is because of the Troy grip, not the adaptor. My old OD green Armalite A2 grip fits perfectly on the adapator. The Troy grip looks nicer and it feels way better than the A2 so I went with it.

[deets]

^^Sweet!! Thats got some nice lines. How do you like that stock, is it easy to sight down the barrel while maintaining a good cheek weld? I have some ghost ring sights and im trying to pick a stock adapter that will be best for me. Right now its between the mesa tactical low tube adapter and the NEA. The only thing I dont like about the NEA is the big hole in the side of it. I dont want to have a swivel mount on my shotgun, is there anything you can do to plug that hole up and looks good?

[Stevo]

I can get a good cheek weld. It might be a tad high for a bead sight but I think it would be perfect for ghost rings.

The swivel hole doesn't seem as noticeable in person. I've never seen anything made to fill them, but I suppose you could jam it full of gummy bears or something similar.

[NeitArms]

If you order one through us we can fill the QD holes with steel putty if you wish. Should color match pretty close too.