you need to round the corners on your firing pin stop a tad so that it rocks back and forth freely and possibly remove a bit more material from the extractor cut out on the barrel.
you need to round the corners on your firing pin stop a tad so that it rocks back and forth freely and possibly remove a bit more material from the extractor cut out on the barrel.
thanks, unless I run into problems (which I doubt), i am going to stick with the stock pistol, and just have the Mitchell right side mag release installed.
Everyone had been telling me that they shoot them pretty well in stock form.
HOT DOGS GIVE ME ENERGY, SO I CAN FIGHT OFF MY DEMONS
Check the factory extractor clearence. Both of mine were not cut deep enough.
Yeah, all of what Madness said was correct - they do need a little fitting (but it's simple while tuning a standard extractor is a black art...) Like the button, since the gun's starting with me, I'd be happy to put it in for you if you decide you want one.
Follow us on Facebook at https://www.facebook.com/freedom.ventures.92
Follow us on Instagram at https://instagram.com/freedom_ventures/
Please do not PM- email us at sales@freedomventures.ca
www.freedomventures.ca (902) 455-5483
thanks again Sean.
HOT DOGS GIVE ME ENERGY, SO I CAN FIGHT OFF MY DEMONS
I have two of these in my Para LDA and Para P16 double stacks. The LDA is a 9mm, the P16 is a 40. I no longer have any issues with extraction. This after having 2 Ed Browns have the claw break. I had to do some filing to fit the firing pin stop on the LDA, but now I have zero issues. Yes, they are both series 80 guns, but the first thing that came out of the guns was that stupid series 80 plunger.
Vince
We have plenty of stock in 9mm / 38 Super Comp, 40 S&W, 45 ACP and 38 Super.
Follow us on Facebook at https://www.facebook.com/freedom.ventures.92
Follow us on Instagram at https://instagram.com/freedom_ventures/
Please do not PM- email us at sales@freedomventures.ca
www.freedomventures.ca (902) 455-5483