Hold off on the filing until you try installing the stock with the safety centered. Have done a few installs never a problem. Check you tube lots of info there.
Hold off on the filing until you try installing the stock with the safety centered. Have done a few installs never a problem. Check you tube lots of info there.
I had the same problem when I did mine.
I noticed that the receiver wasn't sitting all the way back in the channel of the kit, preventing the front from coming down.
I needed 2 people to get mine in, one to put pressure backwards by pushing on the barrel while I tapped it into the kit with a mallot.
The tolerances are so tight, it doesn't take much to get hung up if it doesn't go in exactly square
well mine wouldnt fit so i dremeled a little off and got it in, its still very tight. I smacked my face pulling it back out pulling on barrel :/ i also have the archangel 556 and the receivers fit in perfectly. Im sure mine had too much plastic.
I noticed on mine the barrel's V-block sticks out a wee bit on one side and was digging into the plastic of the marauder stock's inside face.
I shaved down a little of the inside of the stock in that area with a sharp chisel and she slipped in faily easy then.
After you tilt the back of the reciever so you can start to push the barrel end down, only do so when the whole barrel/ receiver is level with the new stock, then push/ seat the whole thing down evenly and straight making sure the "finger scoop out" in the receiver clears the same area in the stock.
HTH,
BB
High Caliber Service Corp, Proudly serving the shooting Community since 2008. Canada’s largest assortment of Firearm accessories online & in store, 33154 1st ave, Mission, BC. V2V 1G4
We offer PAL, RPAL & CORE courses for the Fraser valley/ Vancouver area: www.palcore.ca
Call us at 604-BUY-GUNS, (289-4867) or at hical@shaw.ca
Like us on Facebook for all the latest info
SERVICE is our middle name!
[QUOTE= After you tilt the back of the reciever so you can start to push the barrel end down, only do so when the whole barrel/ receiver is level with the new stock, then push/ seat the whole thing down evenly and straight making sure the "finger scoop out" in the receiver clears the same area in the stock.
HTH,
BB[/QUOTE]
Exactly the way we do them! make sure the safety is in the center position as well.
High Caliber Service Corp, Proudly serving the shooting Community since 2008. Canada’s largest assortment of Firearm accessories online & in store, 33154 1st ave, Mission, BC. V2V 1G4
We offer PAL, RPAL & CORE courses for the Fraser valley/ Vancouver area: www.palcore.ca
Call us at 604-BUY-GUNS, (289-4867) or at hical@shaw.ca
Like us on Facebook for all the latest info
SERVICE is our middle name!
Hi guys,
Just a quick question regarding this mag without the sleeve.... will it fit in a stock ruger, or a ruger with one of the mp5 type looking kits? the way it looks without the sleeve is very close to an Mp5 mag! closer than any of the others IMO!
thanks for now,
ginnz.
Holy smokes man! That thing looks better than the marauder kit IMO! The rear stock is very nice compared to the marauder kit stock! personally i really dis-like the marauder stock.... it almost a deal breaker for me....
the only thing i see thats not very good is there is almost no trigger! you need a longer trigger!
good job!
GiNNz!