deagle2008
CGN Ultra frequent flyer
- Location
- BC
hello everyone
UPDATESost# 35
this is another basic review of the CanAms combo deal
another great deal from CanAm and their great costumer service.
heres the pictures i promised. the M305s i got was soaked in Oil, but the oil was easily removed by Spray9 and rinsed with hot water. the flash hider on this one is welded. looks like the receiver has some welding spots that has been grinned down. i fully disassembled the rifle (including the bolt) and inspected every part. the rifle was oiled and assembled. i used USGI Rifle Grease on every moving part and gun oil to protect the finish. the stock is in ok condition. the rear sight IS s**t. i had a USGI rear sight and installed it . luckily the barrel is indexed correctly. i hate the mags but i believe itll be fixed with my dremel. the ammo is Steel cased copper washed berdan primed, bullet is copper FMJ 143.5 Grain
OH DO NOT DISASSEMBLE THE BOLT if you have no TOOLS or a THIRD HAND
if no tools you can use a 30-06 casing placed in the chamber to push the ejector pin so the extractor fall into place
ENJOY
cheers to yall
heres a link to all the pictures
http://s1220.photobucket.com/albums/dd458/deagle2008/Norinco%20M305%202011/?start=all
UPDATESost# 35
this is another basic review of the CanAms combo deal
another great deal from CanAm and their great costumer service.
heres the pictures i promised. the M305s i got was soaked in Oil, but the oil was easily removed by Spray9 and rinsed with hot water. the flash hider on this one is welded. looks like the receiver has some welding spots that has been grinned down. i fully disassembled the rifle (including the bolt) and inspected every part. the rifle was oiled and assembled. i used USGI Rifle Grease on every moving part and gun oil to protect the finish. the stock is in ok condition. the rear sight IS s**t. i had a USGI rear sight and installed it . luckily the barrel is indexed correctly. i hate the mags but i believe itll be fixed with my dremel. the ammo is Steel cased copper washed berdan primed, bullet is copper FMJ 143.5 Grain
OH DO NOT DISASSEMBLE THE BOLT if you have no TOOLS or a THIRD HAND
if no tools you can use a 30-06 casing placed in the chamber to push the ejector pin so the extractor fall into place
ENJOY
cheers to yall
heres a link to all the pictures
http://s1220.photobucket.com/albums/dd458/deagle2008/Norinco%20M305%202011/?start=all
Last edited: