Allen Gun Works
Revolted
- Location
- Trenton
We finally got our prototypes done for our new flash hider. We have about 10 prototypes we will be sending out to a few people who are going to put them through their paces and see how effective they are compared to comparative products (ie. AAC and Smith)
I am sure someone will notice the machining snafus. The indexer that was used forced the use of a tool that was a bit too long and ended up causing a lot of flex. The process will be adjusted for the production run for sure. It was just easier to get the prototypes off this way and kept the cost down.
These are now available in our E-STORE with a picture of the finished product!!! WWW.ALLENGUNWORKS.COM/STORE
I am sure someone will notice the machining snafus. The indexer that was used forced the use of a tool that was a bit too long and ended up causing a lot of flex. The process will be adjusted for the production run for sure. It was just easier to get the prototypes off this way and kept the cost down.
These are now available in our E-STORE with a picture of the finished product!!! WWW.ALLENGUNWORKS.COM/STORE
Last edited: