-
M14, M305, M1A magazines neutering method
Are the base plates on these magazines tack welded shut and have something internal blocking the follower, or are they left unmolested except for a rivet?
(really hoping for just a rivet)
Oh and with 5 rounds can they be inserted with a closed bolt?
http://www.marstar.ca/dynamic/produc...roductid=80544
-
Member
from what I remember Marstars were not tack welded,welding is stupid How are you to clean a mag.
Last edited by ziggyboy; 03-20-2013 at 12:58 PM.
-
CGN Ultra frequent flyer
Its a rivit and most can close on a closed bolt a few can't depends on if the person doing it was off by a little bit..
-
CGN Regular
My norinco M305 20 round mag came with a rivet in the side stopping the spring, bottom plate is fairly easily removable, Can't remove the spring or follower without removing the rivet. Makes it a huge pain to clean and lube the mag. My five round mag can be installed and removed with the bolt closed.
-
SLAYER8321;
Thank you for replying
John
-
CGN Regular
Just received two new 5/20 round mags today from wolverine, both came with the bottom plate welded and something inside stopping the follower.
-
That sucks how do ya clean them?
-
CGN Ultra frequent flyer
-
CGN frequent flyer
Lever Arms sells the 5/20 mags for the M305 for $35 , great deal and they are pinned by a rivet in spline, action stays open after last shot
-
CGN Regular
I guess the only way to clean is like yomomma said with brake clean or something that you can spray in and would dry without a residue. Mega pain in the behind.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules