With my shotguns I've had good luck with Fluid Film applied appropriately and also have seen success with a thin application of Mil-comm TW25
Anyone shooting these left handed? I hate getting hulls in the face and the cheek riser setup looks like it may be problematic.
I know this is a stupid question but I am on the verge of ordering one but can't decide on color.....does anyone have the "tan" version? IF so, what do you think of it as I understand it is more "burnt copper" than desert tan. I am tired of black and am going back and forth between OD and tan.
00110000001100100010111100110000001100010010111100 11000000110011 & 00110000001100010010111100110010001101010010111100 11000100110000
Lefty here and no problems with hulls in the face. It only sucks if you have ####ty smelling powder like in the Winchester 2 3/4 target shells. It goes straight into the nostrils! Federal target smells good tho btw.
I've found an A2 buffer tube does fit the receiver threads. At first, it didn't seem to, but there was a ton of what I can only assume is thread cement in there. Heat gun, gun cleaner, brass brush, nothing really worked until I got in there with a small nail in some pliers to dig it out. The fit is snug, but screwed in by hand just fine.
Don't be so sensitive snowflake, words can't hurt you.
"Facts don't care about your feelings" Ben Shapiro
If it's on the muzzle it's a brake NOT a break
By the power vested in me as God of my world.