delete
delete
Last edited by metamatt; 06-13-2020 at 12:54 PM.
\"J.R."\
CEO
The Shooting Edge, Target Sports Canada, William Evans
It uses a threaded pin rather than a standard roll pin. Not included in normal LPKs. Looks like brownells has them though. I hope they fit!
Also JR, I'm having trouble getting gen 3 pmags to seat. Looks like its 1 millimeter too high. Gen2 and stanags work though. Is this common? Would you advise removing material from the mag catch lug?
Fight for what you believe in today because tomorrow could just be too late.
When do you expect your pins to be ready to ship? Would it make more sense to wait for yours than try and import pins? Asking for a friend.
Is this the pin?
https://www.brownells.com/rifle-part...rod132472.aspx
I cannot find at TNA, have emailed Zack for a friend....
Last edited by Paul_T; 06-13-2020 at 02:00 PM.
"No matter where you go - there you are"
Sorry... we noted that when we built ours and it is due to the geometry of the lower as it is not a true AR15.... we simply cut about 2mm off the spring as it's nothing really "critical".... it takes very little pressure down on the plunger to hold the detente properly.
JR
\"J.R."\
CEO
The Shooting Edge, Target Sports Canada, William Evans
We tested our model with stanag, gen 2 pmags' e-lander and cross mags... I have no gen 3s to compare with so I cannot advise.
To be honest, we were more concerned with duplicating than "new features" as our MS was a recent production model and certain "assumptions " were just made about reliability and usability.... we wanted this out f.a.s.t!
I have secured enough screw bolt catch pins and will put one in with each set.... gratis.
You poor guys who picked your sets up will have to come in on monday to get one.
JR
Last edited by TSE JR; 06-13-2020 at 04:07 PM.
\"J.R."\
CEO
The Shooting Edge, Target Sports Canada, William Evans