+1 mag extention

[Innercity]

Can someone give me the overall length of one please.
State witch brand it is also.

Thanks.

 

[Drillbit]

What type of shotgun?

Have a Benelli factory +2 that's 4" long....not sure how 2 3/4 fit's into 4 twice though...

 

[870P]

They all seem to fit flush with the end of a 14" bbl is all I know.

 

[Innercity]

Yeah see thats why i was wondering the length. I just bought a 12.5 Grizz and i put the 12.5 barrel on my norinco mag fed, and the 14.5 barrel (from the Norc) on the Grizz.

Now i wan't the tube on the Grizz to be flush with the end of the barrel. But i think the +1 will be short and a +2 too long.

 

[SoBored]

Mine I got used, (it's said to be a Badboybeeson+1), and it is 2.25".

Looks like you might need to start asking about a +2?

 

[badboybeeson]

Yeah see thats why i was wondering the length. I just bought a 12.5 Grizz and i put the 12.5 barrel on my norinco mag fed, and the 14.5 barrel (from the Norc) on the Grizz.

Now i wan't the tube on the Grizz to be flush with the end of the barrel. But i think the +1 will be short and a +2 too long.

Correct
Our +1 will fit flush with a 14 inch bbl. What u have is. 15 inch bbl.
BBB

 

[Innercity]

Thanks BBB.
So how long are the +2 and are they aluminum or steel? As i don't see that shortining one would be too difficult, allthough i don't have one in front of me right now.

 

[badboybeeson]

Our mag tubes are made from a solid block of steel, they are one piece and would not be easy to make smaller.
But we have some factory remington mag tubes that that are made from steel tubing that have an end cap brased on.
You could heat it up and take the cap off, chop the mag tube to size and then brase the cap back on or used industrial epoxy

 

[Innercity]

Thanks. I'll keep that in mind.

 

[Innercity]

Tac ord makes custom length ones this is my new solution

 

[kamlooky]

Not to hi-jack..........to BBB, what would fit on an A-5, 2 3/4"?
And the Winchester Model 120, 2 3/4 and 3"?
Cost of each?
Thanks.
Looky.