Well I'm going to try may hand at Arma-Coating a 10/22, and after getting the trigger group done I knew i had problem. I had the group hanging and every time I'd hit it with spray it would blow all around and sway. Before I tackle the receiver I figured I should build a fixture.
I think it turned out ok. I designed it so if i wanted to do another trigger group it would work for that as well. The receiver bolts to the shaft thru a clearance hole into the stock bolt threaded hole. The trigger group just uses one of the holes. Both can rotate a full 360 and the back of the fixture holds the mounting screws so i don't lose them.
With the Trigger group mounted:
With the receiver mounted:
The back side, showing the stainless mounting hardware:
In Action:
I think it turned out ok. I designed it so if i wanted to do another trigger group it would work for that as well. The receiver bolts to the shaft thru a clearance hole into the stock bolt threaded hole. The trigger group just uses one of the holes. Both can rotate a full 360 and the back of the fixture holds the mounting screws so i don't lose them.
With the Trigger group mounted:
With the receiver mounted:
The back side, showing the stainless mounting hardware:
In Action:
Attachments
Last edited:
