10/22 takedown screw?
- Thread starter Slaymoar
- Start date
wayupnorth
CGN Ultra frequent flyer
- Location
- Northern Alberta
on the same topic, i picked up some Dlask last year, a lot nicer then the stock ruger ones.
instead of the slot they use a Hex or Torque pattern, much nicer for take downs and such, no more slipping off and scratching.
instead of the slot they use a Hex or Torque pattern, much nicer for take downs and such, no more slipping off and scratching.
You've found it, Good. For future reference, Western Gun Parts in Edmonchuck... er... Edmonton most likely have them in stock. Shipping can be a beatch. If you have a friend in Edmonton they can get something and mail it to you it can save you (often) more than the cost of the part...
Obscure parts? I went in many years ago and asked if they had a gas piston for a mini-14... They went in the back and picked one from stock. They had the little tube that connects the gas piston to the port, too.
Obscure parts? I went in many years ago and asked if they had a gas piston for a mini-14... They went in the back and picked one from stock. They had the little tube that connects the gas piston to the port, too.
