10/22 trouble

[The Hippie]

I took out my trigger assembly tonight to clean it and the bolt.
I tried to put it backtogether, and got it together, but the bolt seems to be rubbing on part #B-8
the gun is a regular rugger 10/22, and Westicle installed a new bolt release, trigger kit, and extended mag release. the gun has worked fine for 2k rounds.
I did try puting it back togetehr with part B-8 in the rear position, but figured out pretty quick that it needs to be farward.

I didnt take apart the trigger assembly, just popped out the two pins to take the whole thing out.
any sugestions or help of any kind (other than buy a new gun) would be greatly apreciated.

thanks,
Joe

 

[(Ronin)]

I took out my trigger assembly tonight to clean it and the bolt.
I tried to put it backtogether, and got it together, but the bolt seems to be rubbing on part #B-8
the gun is a regular rugger 10/22, and Westicle installed a new bolt release, trigger kit, and extended mag release. the gun has worked fine for 2k rounds.
I did try puting it back togetehr with part B-8 in the rear position, but figured out pretty quick that it needs to be farward.

I didnt take apart the trigger assembly, just popped out the two pins to take the whole thing out.
any sugestions or help of any kind (other than buy a new gun) would be greatly apreciated.

thanks,
Joe

Had the same problem untill i realised that i had installed the safety backwards, Pull it back apart and flip it the other way but if you didnt take it fully apart,then i have no clue.Good luck
Dan

 

[Hitzy]

if you removed the pin holding the ejector(B8....don't use part numbers) the bolt lock spring may not be in the right spot.
Some links to tigger group assembly:

http://riflestocks.tripod.com/trigger-travel.html
http://www.rimfirecentral.com/forums/showthread.php?t=76722

 

[The Hippie]

I think i have it. i dont know what it was. i took the assembly out and put it back in, put a little oil on it, and worked it back and forth. it sticked for a little, but then i loosend up.
i did take any thing apart, so i dont know what it could be, but the top of part B-8 looks like it has been rubbing and the metal is exposed on top, and i dont think it was like this when i first took it apart.
it seems to be working now though
i was hoping to get out the the range today, but i dont think it will happen.