180 Charging handle question?
- Thread starter 45C
- Start date
I think the trigger pins (as in the pins that hold the trigger mechanism in place) are standard, but I might be wrong.
Way back in 2019 a variant was announced that would utilise a T handle style of charging handle, but I think it died a quiet death.
Ultimately I don't think there's any benefit or demand for the T handle with the 180 platform, but I stand ready to be proven wrong
Way back in 2019 a variant was announced that would utilise a T handle style of charging handle, but I think it died a quiet death.
Ultimately I don't think there's any benefit or demand for the T handle with the 180 platform, but I stand ready to be proven wrong
Right,
I remember something about the rear charging handle.
It would eliminate the the slot cutout in the side of the receiver, wouldn't it?
I think the Jard rifle will have a rear CH,but I'm not gonna Beta test that again
I remember something about the rear charging handle.
It would eliminate the the slot cutout in the side of the receiver, wouldn't it?
I think the Jard rifle will have a rear CH,but I'm not gonna Beta test that again
The WS-180C and WS-MCR use longer than standard trigger pins
The new SBI Lynx 180B lower will use standard pins
Interisting, I can't remember if when I purchased a replacement trigger for my WK whether I used the pins that came with it or not
The Jard 180 has a right side only charging handle. If does, however, have a sealed left side, and the part of the charging handle track not obstructed by the closed bolt control group has a flip down dust cover to prevent detritus infiltration when the rifle is not being fired.
Reports are that the improved material parts provided under warranty fixed many issues with the J180's predecessor; hopefully they have been carried forward to the J180 to make a dependable firearm.
